SAE J444 G25 · GP · 40–51 HRC
G25 Steel Grit
Angular high-carbon cast steel grit for rust and mill-scale removal and surface preparation before coating. Specify it by size, hardness, density and chemistry, then request technical confirmation for your batch.
Proposed purchase limits — not certified performance
These values are proposed purchase limits drawn from broad reported supplier ranges. They are not certified performance. Every batch must be confirmed by its certificate of analysis (COA).
Product properties
| Property | Proposed limit |
|---|---|
| Material | High-carbon cast steel |
| Shape | Angular |
| Microstructure | Tempered martensite |
| Colour | Dark steel grey |
| Condition | Dry, free-flowing |
| Size reference | SAE J444 G25 |
| Nominal sieve | 0.71 mmNot all particles are exactly this size |
| Hardness (GP) | 40–51 HRC |
| Absolute density | ≥ 7.0 g/cm³ |
Chemical acceptance limits (mass fraction)
| Element | Proposed limit |
|---|---|
| C | 0.70–1.20 % |
| Si | ≥ 0.40 % |
| Mn | 0.40–1.20 % |
| S | ≤ 0.05 % |
| P | ≤ 0.05 % |
| Fe | Balance |
Sizing limits — SAE J444 G25
| Sieve opening | Requirement | Basis |
|---|---|---|
| 1.18 mm | All pass | Pass |
| 0.71 mm | > 70 % retained* | Retained |
| 0.425 mm | > 80 % retained* | Retained |
* Sieve limits are reproduced as stated in the supplied sheet and have not been normalised. Confirm the retained/pass basis and method on the batch COA; do not assume cumulative or individual-sieve retention.
Quality control documents per batch
- Batch certificate (COA) required
- Hardness report in HRC
- Density report stating the method
- Chemistry report: C, Si, Mn, S, P
- Sieve report stating the retained / pass basis
- Visual check: angular, clean grit
Applications
- Rust and mill-scale removal
- Steel structures and fabricated parts
- Surface preparation before coating
- Wheel or air blasting, subject to trial
Reusable only in suitable recovery systems.
Sieve limits: Winoa SAE specification sheet. Chemistry and density: broad supplier-reported purchase-review limits. This page does not establish ISO 11124-3 or SAE J1993 conformity. Source: Issue 1 · November 2026.
Compare with blasting garnet
